km flashing

István

Anfänger

Beiträge: 34

Dabei seit: 16. September 2009

Danksagungen: 6

Freitag, 18. September 2009, 15:07

km flashing

Wird nicht angezeigt, wenn Sie angemeldet sind!

Hello!

I need a bit of help

I've installed a multi steering wheel into my car. Every function works very good, but the km number is flashing....I have an "after" connect nav, and without a 4sec time delay the km number should flash too, but with the time delay it works perfect and no flashing.

Shall I joint the "power" cable of the wheel to the time delay too? Or what is the solution?
Lot of thanks.

Themenstarter

StiloNordlicht

Mitgliedschaft beendet

Freitag, 18. September 2009, 17:42

Yes thats the solution , the Can Bus System registers the MuktiWheel as "not provided in this car" and as Reaction the km flashes . Its the same with the Connect Nav.

You need to connect the "can A" and "can B" Cable (from Can Bus to steering Wheel) to the time delay too.An Introduction for building such a time delay you can find here Klick .

With kind regards Eric ;-)

István

Anfänger

Beiträge: 34

Dabei seit: 16. September 2009

Danksagungen: 6

Freitag, 18. September 2009, 17:54

Thanks for the answer. This is very interesting, because, the +12V cable is jointed only to the CN+. So the CN is connected in the delay by the ignition cable.

With the "Mufu" I must joint the Can lines too??

Themenstarter

yellowstilo

Profi

Beiträge: 630

Dabei seit: 7. August 2006

Wohnort: Niederlande

Danksagungen: 1232

Dienstag, 22. September 2009, 18:57

No, only the power line has to be connected to the time delay circuit.

Mein Stilo: 1.6 L 3 türer ginstergelb - DTS gewindefahrwerk , Sedox tuning , Birba weisser Abarth tacho, -4 cm , 17''/ 225-45 , Green Stuff , KN ,Connect Nav+, B-und C-CAN monitor , Examiner Smart und SAM, lederverkleidung, OBD infodisplay

Mein Stilo: 1.6 L 3 türer ginstergelb - koni's ,Birba weisser tacho, -4 cm , 17''/ 225-45 , Green Stuff , KN , B-und C-CAN monitor , Examiner Smart und SAM